Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
- 6. Ignition system
+ 6.1. Start and gymnastics systems
+ 6.2. Ignition system (petrol engines)
- 6.3. System of prestarting heating (diesel engines)
6.3.1. Technical characteristics
6.3.2. Candles накаливания
6.3.3. The block of management of system of prestarting heating
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions
|
Removal
The prevention If the system of prestarting heating just worked or the engine was just switched off, candles накаливания will be very hot.
| PERFORMANCE ORDER |
| 1. Disconnect the negative plug of the accumulator. |
| 2. Remove system of pipes of an air inlet and disconnect a ventilation hose картера from маслозаливной mouths. |
| |
3. Unscrew a fastening nut (it is specified by an arrow) токовой tyres to a candle накаливания. Pay attention that the feeding wire is connected to токовой to the tyre on a candle накаливания the cylinder № 2. |
| 4. If necessary displace aside any pipes and wires to improve access to a removed candle накаливания. |
|
5. Unscrew a candle накаливания and take from the block of cylinders. |
|
Check
| PERFORMANCE ORDER |
| 1. Check up each candle накаливания on presence of mechanical damages. The reason of that candle tips накаливания are burnt or destroyed, there can be a bad stream of dispersion of fuel an atomizer. If there is such damage, it is necessary to check up and if necessary to replace fuel atomizers. |
| 2. If candles накаливания have no mechanical damages, check up their electric resistance which should be less than 1 Ohm. |
| 3. Working capacity of candles накаливания can be checked up, submitting on them of 12 volt. Thus they should heat up in regular intervals and for a demanded interval of time. |
4. Thus it is necessary to observe safety measures:
– To hold a candle накаливания a special clip or flat-nose pliers;
– The electric feed circuit of a candle накаливания should have the fuse;
– After check the candle накаливания should be cooled within several minutes. |
| 5. The candle накаливания in a good condition heats up to reddening of a working tip within 5 seconds. At longer heating or heating in an average part, instead of on the candle end, the candle is faulty and is subject to replacement. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in sequence, return to removal. |
| 2. Thus it is necessary to grease a carving part of a candle антипригарным with structure on the basis of copper. |
|
|
|