Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. Transmissions
   - 8.1. A mechanical transmission
      8.1.1. Technical data
      8.1.2. Oil replacement in a transmission
      8.1.3. Management of a gear change (transmission BE3)
      8.1.4. A trosovyj drive of a gear change (transmission ML5T)
      8.1.5. Replacement of sealing rings
      8.1.6. The switch of a lantern of a backing
      8.1.7. The gauge of a drive of a speedometer
      8.1.8. Removal and installation of transmission ВЕ3
      8.1.9. Mechanical transmission ML5T
   + 8.2. An automatic transmission
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

8.1.2. Oil replacement in a transmission

THE GENERAL DATA

Plums of oil from a transmission will be faster and effective if this operation to make after warming up of the engine to working temperature and carrying out of a control trip for transmission warming up.

PERFORMANCE ORDER

1. Lift the car on the lift or establish over a viewing hole.

2. On the cars equipped with transmission ВЕ3, remove the left forward wheel, unscrew screws and remove protection of an arch of a wheel from under a wing for access to a stopper of pouring of oil. On all models remove a mudguard from under the engine.

3. Wipe area round a stopper of pouring of oil. On transmission ВЕ3 the stopper of pouring of oil is the biggest bolt among bolts of fastening of a face cover to a transmission. On transmission ML5T the stopper of pouring of oil is located on a back part of a casing of differential. Unscrew a stopper of pouring of oil from a transmission.

4. Establish the corresponding container under маслосливной a stopper located in a back part of a transmission, and unscrew a stopper.

5. Completely merge oil from a transmission. Clear a stopper of pouring of oil and маслосливную a stopper of metal particles and replace sealing washers.

6. Screw up маслосливную a stopper and tighten its demanded moment.

7. Fill in oil in a transmission to bottom edge level маслозаливного apertures.
The prevention
For correct filling of a transmission the car should be in horizontal position.

8. Screw up a stopper of pouring of oil, establish a wheel and make a short trip. Repeatedly check up oil level.

9. If necessary modify oil level, establish a new sealing washer on a stopper, screw in a stopper into place and tighten the demanded moment. Establish protection of an arch of a wheel and an engine mudguard.