Peugeot 406

Since 1996 of release

Repair and car operation

8.1.3. Management of a gear change (transmission BE3) Removal

PERFORMANCE ORDER

1. Remove the central console. 2. Lift a forward part of the car and fix on supports. 3. Remove system of release of the fulfilled gases and the heat-shielding screen. Unscrew a nut and remove шарнирный a bolt, крепящий a gear change rod to the basis of the lever of a gear change. 4. Using a screw-driver, take lock washers of fastening of three cores of communication (are specified by arrows) to spherical шарнирным to connections on a transmission. Disconnect a rod of a gear change from a point of turn of the angular lever and remove it from below the car. 5. Separate by means of the lever a plastic head from a bolt, крепящего the lever of a gear change with the angular lever and the bottom frame. 6. Unscrew шарнирный a bolt of fastening of the angular lever and remove the angular lever and draught from under the car. 7. Examine all elements on presence of deterioration or damages. If necessary remove the gear change lever as follows. 8. Unscrew lock nuts of the lever of a gear change and lift a fastening plate. 9. Remove the bottom sheeting from the lever basis, then disconnect a plate of installation of the lever and remove the top sheeting of the lever for access to the spherical hinge of a point of turn of the lever.

Installation

PERFORMANCE ORDER

Installation is made in sequence, return to removal, taking into account following moments:       – Grease with greasing on a basis дисульфида molybdenum all mobile connections;       – Check up that all protective rubber coverings of the lever of a gear change are established on the places;       – Establish thermofilters and an exhaust system.