Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
- 13. An electric equipment
   13.1. Technical data
   13.2. Detection of not closed chain
   13.3. Safety locks and the relay
   13.4. Switches
   13.5. Bulbs of external illumination
   13.6. Lamps of illumination of salon
   13.7. Devices of external illumination
   13.8. Adjustment of light of headlights
   13.9. A combination of devices
   13.10. The multipurpose display
   13.11. Прикуриватель
   13.12. Hours
   13.13. A sound signal
   13.14. The screen wiper lever
   13.15. The screen wiper and draught engine
   13.16. A back screen wiper
   13.17. Стеклоомыватель
   13.18. An automobile radio tape recorder
   13.19. A column (dynamics)
   13.20. The aerial
   13.21. A cruise-control control system
   13.22. Anticreeping system and an engine immobilizer
   13.23. Electric units of forward sitting
   13.24. A safety pillow
   13.25. Elements of a pillow of safety
   + 13.26. Electric schemes
+ 14. The basic malfunctions

13.15. The screen wiper and draught engine

Removal and installation

1. Remove the negative plug from the accumulator.
2. Remove the screen wiper lever.
3. Unscrew a lock nut.
4. Remove the left and right plastic covers of system of ventilation from the windshield basis.
5. Remove the left and right elements of system of ventilation in the bottom part of a windshield for access to the screen wiper engine.
6. Disconnect the electric socket located on wires of a food of the engine of a screen wiper.
7. Unscrew nuts and bolts (fastenings of a screen wiper are specified by arrows in a photo at the left) and take a screen wiper (a photo on the right).
8. Remove rubber демпфирующие linings from a screen wiper.
9. If necessary note relative position of a shaft of the electric motor and a crank, unscrew a nut (1) and remove draught of a screen wiper from an electric motor shaft. Unscrew bolts (2) fastenings of the engine and remove from it draughts.
10. Installation is made in sequence, return to removal.