Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
- 13. An electric equipment
   13.1. Technical data
   13.2. Detection of not closed chain
   13.3. Safety locks and the relay
   13.4. Switches
   13.5. Bulbs of external illumination
   13.6. Lamps of illumination of salon
   13.7. Devices of external illumination
   13.8. Adjustment of light of headlights
   13.9. A combination of devices
   13.10. The multipurpose display
   13.11. Прикуриватель
   13.12. Hours
   13.13. A sound signal
   13.14. The screen wiper lever
   13.15. The screen wiper and draught engine
   13.16. A back screen wiper
   13.17. Стеклоомыватель
   13.18. An automobile radio tape recorder
   13.19. A column (dynamics)
   13.20. The aerial
   13.21. A cruise-control control system
   13.22. Anticreeping system and an engine immobilizer
   13.23. Electric units of forward sitting
   13.24. A safety pillow
   13.25. Elements of a pillow of safety
   + 13.26. Electric schemes
+ 14. The basic malfunctions

13.22. Anticreeping system and an engine immobilizer

The prevention

This information concerns only the anticreeping system established Peugeot as the standard equipment.

The anticreeping system joins and switched off by the tiny transmitter. After inclusion of system the indicator located on the central console, is constantly shone. In addition to anticreeping system there is an immobilizer preventing start of the engine of the car. The immobilizer is disconnected key колодкой, established in the panel of devices from outside the driver. The control lamp of an immobilizer is located in the central part of the panel of devices.

Anticreeping system of the alarm system

The prevention

If car doors are closed and open a key the anticreeping system will not submit an alarm signal. If during giving of an alarm signal the transmitter does not switch off system, it can be disconnected by means of a key. For this purpose open a door a key and enter into the car. Thus the alarm signal will sound, as the door is opened. Include ignition and press the small alarm button located on the central console. These actions are necessary for executing within 10 seconds after door opening.

The anticreeping system has switches on a cowl, a back door and lateral doors, and also gauges of movement in the car. For switching-off of anticreeping system include ignition and press the button on the central console for 2 seconds then for 3 seconds the control lamp of anticreeping system will light up that will specify in its switching-off. For repeated inclusion of anticreeping system include it by means of the remote control transmitter.

The prevention

Do not forget an immobilizer code. If it is impossible to enter a correct code, an electronic control control mean the engine it is necessary to replace.

The immobilizer prevents engine start if the special code is not entered into the control panel by an immobilizer located in the bottom part of the panel of devices from outside of the driver. The immobilizer code can be changed at will. If at inclusion of ignition the immobilizer control panel is shined by green light, the engine can be запушен without a set of a code of an immobilizer. If the immobilizer control panel is shined by red light, the engine will not be started and the alarm signal will start to sound at its start.

Accumulator detachment

Before an accumulator detachment the anticreeping system should be switched off completely. After accumulator connection it is necessary to make active anticreeping system the remote control transmitter.