Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
- 8. Transmissions
   + 8.1. A mechanical transmission
   - 8.2. An automatic transmission
      8.2.1. Technical data
      8.2.2. Oil replacement in a transmission
      8.2.3. Removal and installation of a cable of the selector
      8.2.4. Removal and installation of a drive of a speedometer
      8.2.5. Removal and cooler installation
      8.2.6. Removal and installation of the multipurpose switch
      8.2.7. Removal and installation of the electronic control device (ECU)
      8.2.8. Removal and installation of an automatic transmission
      8.2.9. Major repairs of an automatic transmission
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

8.2.2. Oil replacement in a transmission

PERFORMANCE ORDER

1. Make a short trip for finishing of a transmission to working temperature.

2. Establish the car on the lift or over a viewing hole.

3. Take the index of level of oil, then establish the suitable container under a drain stopper of a transmission. The drain stopper is located in the centre картера transmissions.

4. Unscrew a drain stopper and merge oil from a transmission. Pay attention that merges only about 3 litres of oil since it is impossible to merge completely oil from the hydrotransformer. Clear a drain stopper and remove from a stopper a sealing washer.

5. Establish a sealing washer on a stopper and screw up a stopper into place.

6. Fill in oil in a transmission through a pipe of a measuring instrument of level of oil.

7. In process доливки oils constantly supervise oil level. At achievement of level to a mark "MAX" on a level measuring instrument stop доливку. Start the engine in an idling mode for some minutes. Switch off the engine and check up oil level, if necessary add oil. Make a control trip and repeatedly check up oil level.