Peugeot 406

Since 1996 of release

Repair and car operation


Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions



10.12. The back brake cylinder

Removal

PERFORMANCE ORDER
1. Remove a brake drum.
2. Using a G-shaped clip, press a brake hose in a place closest to the working brake cylinder.
3. Using flat-nose pliers, remove the top spring compressing brake колодки. Remove the top ends brake колодок from pistons of the working brake cylinder.
4. Remove a dirt round a junction of a brake hose and a back part of the working brake cylinder.
5. Unscrew a connecting nut. Being careful, take a brake pipe from the working brake cylinder. Close its stoppers.
6. Unscrew 2 bolts of fastening of the working brake cylinder to a brake board. Being careful, remove the working brake cylinder.
7. If the brake cylinder has defects, it is necessary to replace it completely since separate parts for it are not delivered.

Installation

PERFORMANCE ORDER
1. Check up that interfaced surfaces on a brake board and the working brake cylinder the pure. Establish the brake cylinder into place.
2. Establish a brake pipe in the brake cylinder and on 2–3 turns screw a connecting nut.
3. Screw in 2 bolts of fastening of the working brake cylinder to a brake board and tighten their demanded moment. Definitively tighten a nut of fastening of a brake pipe to the working brake cylinder.
4. Remove a clip from a brake hose.
5. Establish the top parts brake колодок in grooves of the piston of the working brake cylinder. Establish the top returnable spring brake колодок.
6. Establish a brake drum.
7. Remove air from brake system.