Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10.24. The vacuum pump (cars with the diesel engine)


1. For access improvement to the vacuum pump remove a tube of giving of air in the air filter.
2. Ослабьте a collar also disconnect a vacuum hose from the pump.
3. Unscrew bolts / of a nut of fastening of the pump to the left forward party of a head of the block of cylinders.
4. Remove the pump from the engine. On engines in volume of 1.9 litres the pump has 2 sealing rings, on engines in volume of 2.1 litres – 1 ring. Sealing rings are subject to obligatory replacement.


1. Establish a new sealing ring (arrows) in pump dredging.
2. Combine a ledge on a shaft of the pump with a groove of a camshaft and establish the pump on a head of the block of cylinders. Thus do not displace a sealing ring (the ledge and a groove are specified by arrows).
3. Fix the pump bolts / nuts.
4. Connect a vacuum hose to the pump and fix its collar.