Peugeot 406

Since 1996 of release

Repair and car operation


Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions



10.20. Brake колодки a manual brake (model with disk brakes)

Removal

PERFORMANCE ORDER
1. Remove a brake disk and note an arrangement of all details of a manual brake.
2. Using a special key, compress the top fixing spring brake колодки, turn it on 90 ° and remove from a brake board.
3. Disconnect the top returnable spring brake колодок.
4. Release and remove a regulator.
5. Release top колодку from the mechanism of a release and remove the bottom returnable spring brake колодок.
6. Remove the bottom fixing spring brake колодки and remove колодку a manual brake.
7. Disconnect (marksman) a cable of a manual brake from the mechanism of a release brake колодок.
8. Check up a condition and deterioration brake колодок a manual brake. The minimum thickness of an overlay brake колодки makes 1 mm. At installation колодок it is necessary to use new returnable springs.

Installation

PERFORMANCE ORDER
1. Clear details of a back brake. On contact places колодок with a brake board put lubricant with a fusion heat.
2. Check up that the mechanism of a release brake колодок is correctly collected, then connect it to the end of a cable of a manual brake.
3. Establish bottom колодку a manual brake and fix its fixing spring.
4. Establish top колодку and the bottom returnable spring. Check up correctness of installation top brake колодки and fix its fixing spring.
5. Establish a regulator between brake колодками. Establish capture of the top returnable spring on bottom колодку, then on top колодку.
6. Centre position brake колодок.
7. Establish a brake disk.