Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10.5. Replacement back brake колодок

THE GENERAL DATA

The prevention
Necessarily make replacement of all колодок on one axis of the car even if deterioration borders were reached by one колодка.

PERFORMANCE ORDER

1. Lift a back part of the car and fix on supports. Remove back wheels.

2. Remove spring clamps (are specified by arrows), крепящие the pins keeping brake колодки.

3. Remove a spring preventing vibration колодок.

4. Using flat-nose pliers, take internal and external brake колодки from a support.

5. Measure a thickness of an overlay of everyone brake колодки.

6. If колодки are suitable to the further operation, clear them, using a wire brush and rags.

7. Before installation колодок check up that directing plugs easily move in a support and rubber protective covers are not damaged.

8. If will be established new brake колодки, press the piston into a support a wooden core or the hammer handle. Thus watch, that the piston has not warped, and surfaces of the piston and пыльника have not been damaged. At вдвигании the piston the brake liquid is superseded from the brake cylinder in a broad tank, therefore constantly observe of liquid level in a tank, and if necessary pump out from a tank its small amount.

9. Establish brake колодки in a support.

10. Establish into place a spring preventing vibration колодок. Establish the pins keeping колодки, passing them through an aperture in a support, brake колодке and the centre of the spring preventing vibration колодок. Fix pins spring clamps.

11. Some times press a brake pedal that brake колодки have nestled on a brake disk. Check up level of a brake liquid in a tank. Check up that the internal ledge колодки was correctly combined with one of grooves of the piston of a support.

12. Repeat the actions set forth above on the second wheel.

13. Establish wheels and lower the car.

14. Check up level of a brake liquid.