Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

10.22. The stoplight switch

THE GENERAL DATA

The stoplight switch is located on an arm of a pedal of a brake.

On models with an automatic transmission there are 2 switches located on an arm of a pedal of a brake. From them the stoplight switch – left.
Removal

PERFORMANCE ORDER

1. Uncover boxes with fuses.

2. Disconnect a socket from key колодки.

3. Unscrew screws and remove the bottom furnish of the panel of devices. Access to the stoplight switch (it is specified by an arrow) is strongly complicated and can be improved if to remove a steering column.

4. Disconnect an electric socket, unscrew the switch and remove it from an arm.

Installation

PERFORMANCE ORDER

1. Screw in the stoplight switch in an arm so that the backlash between the end of the case of the switch and a ledge on a brake pedal made 2–3 mm.

2. Connect an electric socket to the switch and check up work of stoplights. Stoplights should light up after the brake pedal is pressed approximately 5 mm.