Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
- 10. Brake system
   10.1. Technical data
   10.2. Prorolling of hydraulic brake system
   10.3. Brake pipelines and hoses
   10.4. Replacement of lobbies brake колодок
   10.5. Replacement back brake колодок
   10.6. Replacement back brake колодок on drum-type brakes
   10.7. A forward brake disk
   10.8. A back brake disk
   10.9. A back brake drum
   10.10. A support of a forward brake
   10.11. A support of a back wheel
   10.12. The back brake cylinder
   10.13. The main brake cylinder
   10.14. A brake pedal
   10.15. The vacuum amplifier of brakes
   10.16. The unilateral valve of the vacuum amplifier of brakes
   10.17. Adjustment of a manual brake
   10.18. The lever of a manual brake
   10.19. A cable of a manual brake
   10.20. Brake колодки a manual brake (model with disk brakes)
   10.21. The valve of adjustment of pressure in brake system
   10.22. The stoplight switch
   10.23. Antiblocking system of brakes (ABS)
   10.24. The vacuum pump (cars with the diesel engine)
   10.25. Check of the vacuum pump on cars with diesel engines
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions


soaptoday

10.8. A back brake disk

Check

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports.
2. Remove a corresponding back wheel.
3. Examine a disk as it is described in subsection 10.7.

Removal

PERFORMANCE ORDER
1. Take a brake hose from скобы the fastenings, the nave located on a forward part.
2. Unscrew a bolt of fastening of a support.
3. Remove a protective head from the directing plug.
4. Unscrew a bolt of fastening of a directing pin.
5. Remove a support from a brake disk and, using a soft wire, adhere it to a suspension bracket spring. Thus do not bend and do not stretch a brake hose.
6. Using a chalk or a paint, note an arrangement of a disk concerning a nave. Unscrew screws, крепящие a disk to a nave (are specified by arrows).
7. Check up that the manual brake is completely released, and remove a brake disk from the car. If the disk is still clamped brake колодками in spite of the fact that the manual brake is released, unscrew a regulator of a manual brake.

Installation

Before wheel installation adjust колодки a manual brake.

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Check up that working surfaces of a brake disk and a nave pure and are not deformed.
3. Combine earlier made labels.
4. Use solvent for removal of a protective film from a disk.
5. Clear a carving for bolts of fastening of a support and a directing finger and cover with their means against unscrewing.
6. Establish a wheel and lower the car. Some times press a brake pedal that brake колодки were established into position.