Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   - 3.1. Petrol engines
      3.1.1. Technical data
      3.1.2. Check of pressure of compression
      3.1.3. Mechanism installation timing
      3.1.4. A cover of a head of the block of cylinders
      3.1.5. A pulley of a cranked shaft
      3.1.6. A casing of a gear belt
      3.1.7. A gear belt
      3.1.8. The mechanism of a tension of a gear belt and pulleys
      3.1.9. Replacement of a sealing ring of a cam-shaft
      3.1.10. A cam-shaft and pushers
      3.1.11. Check and adjustment of backlashes of valves of engines of 1.6 litres
      3.1.12. A head of the block of cylinders
      3.1.13. The oil pallet
      3.1.14. The oil pump
      3.1.15. An oil radiator
      3.1.16. Replacement of consolidations of a cranked shaft
      3.1.17. A flywheel
      3.1.18. A suspension bracket of the power unit
   + 3.2. Diesel engines
   + 3.3. Engine repair
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

3.1.16. Replacement of consolidations of a cranked shaft

PERFORMANCE ORDER

The right consolidation коленвала

1. Remove a pulley коленвала and a gear belt of a drive. Measure depth of installation of consolidation.

2. Drill in consolidation two small apertures, located in the opposite ends of consolidation. Screw in two self-cutting screws in the drilled apertures of consolidation and, using flat-nose pliers, extend for heads of screws a sealing ring.

3. Clear a consolidation nest.

4. Grease with pure engine oil working edges of a new sealing ring and establish it on коленвал. Working edges of a new sealing ring should be directed inside.

5. Using corresponding оправку, press a sealing ring into a nest on the depth equal to depth of installation of an old sealing ring.

6. Remove all traces of engine oil and establish a pulley коленвала.

The left consolidation коленвала

7. Remove a flywheel. Measure depth of installation of a sealing ring in a nest.

8. Drill in consolidation two small apertures, located in the opposite ends of consolidation. Screw in two self-cutting screws in the drilled apertures of consolidation and, using flat-nose pliers, extend for heads of screws a sealing ring.

9. Clear a consolidation nest.

10. Grease with pure engine oil working edges of a new sealing ring and establish it on коленвал. Working edges of a new sealing ring should be directed inside.
11. Using corresponding оправку press a sealing ring into a nest on the depth equal to depth of installation of an old sealing ring.
12. Remove all traces of engine oil and establish a flywheel.