Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical data
      3.2.2. Check of pressure of compression
      3.2.3. Mechanism installation timing
      3.2.4. A cover of a head of the block of cylinders
      3.2.5. A pulley of a cranked shaft
      3.2.6. A casing of a gear belt
      3.2.7. A gear belt
      + 3.2.8. Pulleys of a gear belt
      + 3.2.9. The right engine mount and the mechanism of a tension of a gear belt
      3.2.10. A directing roller of a gear belt
      3.2.11. A cam-shaft and pushers
      3.2.12. Check and adjustment of backlashes of valves
      + 3.2.13. Removal and installation of a head of the block of cylinders (engines of 1.9 litres)
      3.2.14. Removal and installation of the oil pallet
      3.2.15. Removal and installation of the oil pump
      + 3.2.16. Replacement of sealing rings коленвала
   + 3.3. Engine repair
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions


быстрая химчистка одежды в москве
быстрая химчистка одежды в москве

3.2.5. A pulley of a cranked shaft Removal

PERFORMANCE ORDER
1. Remove auxiliary приводной a belt.
2. For fixing коленвала the engine from проворачивания the assistant should include the fourth transfer and press against the stop a foot brake or remove a starter and fix a gear wreath of a flywheel (the tool for fixing of a gear flywheel is specified by an arrow). At this time ослабьте a bolt of fastening of a pulley коленвала. A bolt of fastening of a pulley it is necessary to use always the new.
3. Unscrew a bolt and remove a pulley with коленвала. If the pulley is established on sliding landing on коленвал with application шпонки or a pin, remove them. If a pulley напрессован on коленвал, remove it by means of a stripper.

Installation

PERFORMANCE ORDER
1. Establish segment шпонку in a flute коленвала and establish a pulley on коленвал, combining a groove on a pulley with segment шпонкой.
2. Clear a carving of a bolt of fastening of a pulley and grease with its means against unscrewing (Peugeot recommends use Loctite Frenetanche).
3. Screw up a bolt with a washer of fastening of a pulley.
4. Establish and adjust a tension auxiliary приводного a belt.