Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   - 3.3. Engine repair
      3.3.1. Technical data
      3.3.2. Removal and engine and transmission installation
      3.3.3. Removal and installation of engines from an automatic transmission
      3.3.4. Engine repair
      3.3.5. Removal and installation of a head of the block of cylinders
      3.3.6. Dismantling of a head of the block of cylinders
      3.3.7. Clearing and survey of a head of the block of cylinders
      3.3.8. Assemblage of a head of the block of cylinders
      3.3.9. Removal of pistons from rods
      3.3.10. Removal коленвала
      3.3.11. The block of cylinders
      3.3.12. Pistons and rods
      3.3.13. Коленвал
      3.3.14. Survey radical and шатунных bearings
      3.3.15. Engine balance of assembly at major repairs
      3.3.16. Installation of piston rings
      + 3.3.17. Installation коленвала and check of working backlashes of radical bearings
      + 3.3.18. Installation of pistons
      3.3.19. Start of the engine after major repairs
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

3.3.6. Dismantling of a head of the block of cylinders

PERFORMANCE ORDER

1. Remove a head of the block of cylinders.

2. If are not removed, remove inlet and final collectors.

3. Remove a cam-shaft, pushers and linings.

4. On diesel engines remove candles накаливания. On diesel engines in volume of 2.1 litres remove the central part of the mechanism of a tension of a gear belt, having unscrewed a nut of fastening and a hairpin.

5. Remove hairpins of fastening of the mechanism of a tension of a gear belt.

6. Using the adaptation for compression of a spring of the valve, compress each spring and remove crackers from a valve end face. Remove the adaptation for compression of a spring and take a spring plate, a spring and a spring nest. Flat-nose pliers, being careful, take маслоотражательное a ring from a valve rod.

7. Remove the adaptation for compression of a spring and take a spring plate.

8. Remove a spring and a spring nest. Flat-nose pliers, being careful take маслоотражательное a ring from a valve rod.

9. When the valve spring is compressed also a spring cup does not act in film from crackers, it is necessary to strike easily a hammer through wooden брусок on a spring cup that will lead to clearing of crackers.

10. Take the valve through the combustion chamber.
11. Each valve store in a separate polyethylene package together with a spring plate, a spring, a nest of a spring and crackers for their further installation on the places.