Peugeot 406

Since 1996 of release

Repair and car operation



Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   + 3.2. Diesel engines
   - 3.3. Engine repair
      3.3.1. Technical data
      3.3.2. Removal and engine and transmission installation
      3.3.3. Removal and installation of engines from an automatic transmission
      3.3.4. Engine repair
      3.3.5. Removal and installation of a head of the block of cylinders
      3.3.6. Dismantling of a head of the block of cylinders
      3.3.7. Clearing and survey of a head of the block of cylinders
      3.3.8. Assemblage of a head of the block of cylinders
      3.3.9. Removal of pistons from rods
      3.3.10. Removal коленвала
      3.3.11. The block of cylinders
      3.3.12. Pistons and rods
      3.3.13. Коленвал
      3.3.14. Survey radical and шатунных bearings
      3.3.15. Engine balance of assembly at major repairs
      3.3.16. Installation of piston rings
      + 3.3.17. Installation коленвала and check of working backlashes of radical bearings
      + 3.3.18. Installation of pistons
      3.3.19. Start of the engine after major repairs
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions



3.3.8. Assemblage of a head of the block of cylinders
PERFORMANCE ORDER
1. Grease cores of valves with engine oil and insert them on the places. Valves establish on those places where they have been ground in.
2. Establish a spring nest. Lower маслоотражательный a cap in fresh engine oil and establish it on a valve core into place, being careful not to damage its working edges. For installation маслоотражателных caps use special metal оправку.
3. Establish клапанную a spring and a spring plate.
4. The special adaptation compress клапанную a spring and establish crackers in dredging of a core of the valve and grease them. Remove the adaptation for spring compression. Repeat this operation on other valves.
5. With a hammer through wooden брусок knock on an end face of a core of the valve that all elements of the valve were accurately established on the places.
6. Establish a cam-shaft, pushers and linings.
7. Establish other details in sequence, return to removal. If necessary replace linings. On diesel engines of 2.1 litres establish the mechanism of a tension of a gear belt.