Peugeot 406

Since 1996 of release

Repair and car operation

3.2.13.1. A choice of a lining of a head of the block of cylinders

THE GENERAL DATA

Выступание the piston	Lining identification on a thickness
From 0,54 to 0,65 mm	1 cut
From 0,65 to 0,77 mm	2 cuts
From 0,77 to 0,82 mm	3 cuts

PERFORMANCE ORDER

1. Check up that the gear belt is removed from a pulley of the fuel pump of a high pressure, then turn коленвал before installation of pistons of 1st and 4th cylinders in ВМТ. Establish the indicator of hour type on an arm on the block of cylinders. Establish a measuring tip on the block of cylinders and establish an indicator scale on a zero. Establish a measuring tip on the piston of the first cylinder and slightly turn коленвал in both parties. Note the highest value on the indicator and write down this value. 2. Similarly, measure выступание the piston on the cylinder №4, then turn коленвал on 180 ° and repeat measurements выступания pistons on cylinders 2 and 3. 3. In the absence of the indicator of hour type, выступания pistons it is possible to measure size by a calliper, however with smaller accuracy. 4. Using the great value выступания the piston, define a demanded lining of a head of the block of cylinders (And – the cuts specifying for a thickness of a lining). Pay attention that cuts on a lining, located is more subcentral, are identification cuts () and have no value for a thickness of a lining.