Peugeot 406

Since 1996 of release

Repair and car operation


Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. The engine
   + 3.1. Petrol engines
   - 3.2. Diesel engines
      3.2.1. Technical data
      3.2.2. Check of pressure of compression
      3.2.3. Mechanism installation timing
      3.2.4. A cover of a head of the block of cylinders
      3.2.5. A pulley of a cranked shaft
      3.2.6. A casing of a gear belt
      3.2.7. A gear belt
      + 3.2.8. Pulleys of a gear belt
      - 3.2.9. The right engine mount and the mechanism of a tension of a gear belt
         3.2.9.1. The right engine mount
         3.2.9.2. The mechanism of a tension of a gear belt
      3.2.10. A directing roller of a gear belt
      3.2.11. A cam-shaft and pushers
      3.2.12. Check and adjustment of backlashes of valves
      + 3.2.13. Removal and installation of a head of the block of cylinders (engines of 1.9 litres)
      3.2.14. Removal and installation of the oil pallet
      3.2.15. Removal and installation of the oil pump
      + 3.2.16. Replacement of sealing rings коленвала
   + 3.3. Engine repair
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
+ 11. A suspension bracket and a steering
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions



3.2.9.2. The mechanism of a tension of a gear belt
THE GENERAL DATA

Arrangement of a gear belt on the engine

1. Bolts of fastening of a suspension bracket

2. Плунжер the mechanism of a tension of a gear belt


Removal

PERFORMANCE ORDER
1. Remove a suspension bracket and auxiliary приводной a belt.
2. Support the engine a jack through wooden брусок.
3. Unscrew two bolts of fastening and remove from the engine a suspension bracket element.
4. Combine adjusting apertures in pulleys of a cam-shaft, the fuel pump and a flywheel and fix their bolts and cores.
5. Ослабьте a nut of a point of turn of the mechanism of a tension of a gear belt and an adjusting bolt, then turn a suspension bracket of the mechanism of a tension counter-clockwise until the adjusting bolt will not appear in the middle of a groove, and tighten it.
6. Note a direction of movement of a gear belt and remove it from pulleys.
7. Make the tool to compress плунжер the tension mechanism in an installation suspension bracket. The special tool is intended for installation in two bottom apertures under suspension bracket bolts.
8. Unscrew two bottom bolts of fastening of a suspension bracket and establish the special tool. Grease an internal surface of the tool to exclude any damage of an end face плунжера. Unscrew a nut of a point of turn and an adjusting bolt and remove knot of the mechanism of a tension.
9. Unscrew two remained bolts of fastening of a suspension bracket and remove a suspension bracket.
10. Press плунжер the tension mechanism into a suspension bracket, remove the special tool and take плунжер and a spring.

Installation

Installation is made in sequence, return to removal.