Peugeot 406

Since 1996 of release

Repair and car operation


Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. A suspension bracket and a steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward bearings of a nave
   11.4. A forward rack
   11.5. Repair of a forward rack
   11.6. The bottom lever of a forward suspension bracket
   11.7. The bottom spherical hinge of a forward suspension bracket
   11.8. The stabilizer of cross-section stability of a forward suspension bracket
   11.9. A side scene of the stabilizer of cross-section stability of a forward suspension bracket
   11.10. The bottom frame of a forward suspension bracket
   11.11. A nave of a back wheel
   11.12. Replacement of bearings of a back nave
   11.13. The shock-absorber of a back suspension bracket
   11.14. A cylindrical spring of a back suspension bracket
   11.15. A pin of a nave of a back suspension bracket
   11.16. The bottom lever of a back suspension bracket
   11.17. The top lever of a back suspension bracket
   11.18. The directing lever of a back suspension bracket
   11.19. Draught of a back suspension bracket
   11.20. The stabilizer of cross-section stability of a back suspension bracket
   11.21. A side scene of the stabilizer of cross-section stability of a back suspension bracket
   11.22. A steering wheel
   11.23. A steering column
   11.24. An intermediate shaft of a steering column
   11.25. The ignition lock
   11.26. The steering mechanism
   11.27. Replacement of protective covers of the steering mechanism
   11.28. Removal of air from system of a steering with the amplifier
   11.29. The pump of the amplifier of a steering
   11.30. The spherical hinge of steering draught
   11.31. Steering draught
   11.32. Corners of installation of wheels
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions



11.19. Draught of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports. Remove a corresponding back wheel.
2. Establish a jack under the external end of the bottom lever and lift it so that the spring was slightly compressed.
3. Put combination labels between a special washer internal шарнирного a bolt and the bottom frame. At draught installation these labels will allow to keep corners of installation of a back wheel.
4. Unscrew a nut of fastening of the spherical hinge of back bent for to a pin and take the spherical hinge from a pin.
5. Unscrew a nut of fastening internal шарнирного a bolt and remove a special washer. Take шарнирный a bolt and remove back draught from the car.
6. Completely clear draught of a dirt and an anticorrosive covering. Check up its condition.

Installation

PERFORMANCE ORDER
1. Clear a carving шарнирного a bolt and the spherical hinge and grease a surface of contact of new nuts with greasing Molykote G Rapide Plus.
2. Establish back draught into place and insert шарнирный a bolt. Establish on a bolt a special washer so that it was correctly established on a bolt and has taken places against a ledge on the bottom frame. Fix its new nut, without tightening definitively. Combine the labels made before removal, and tighten a bolt of fastening by the demanded moment.
3. Establish the spherical hinge in a pin and fix a new nut, tightening its demanded moment.
4. If necessary make adjustment of corners of installation of a back wheel.