Peugeot 406

Since 1996 of release

Repair and car operation

Peugeot 406
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. The engine
+ 4. Systems of cooling, heating and ventilation
+ 5. Fuel system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmissions
+ 9. Power shafts
+ 10. Brake system
- 11. A suspension bracket and a steering
   11.1. Technical data
   11.2. Rotary fists
   11.3. Replacement of forward bearings of a nave
   11.4. A forward rack
   11.5. Repair of a forward rack
   11.6. The bottom lever of a forward suspension bracket
   11.7. The bottom spherical hinge of a forward suspension bracket
   11.8. The stabilizer of cross-section stability of a forward suspension bracket
   11.9. A side scene of the stabilizer of cross-section stability of a forward suspension bracket
   11.10. The bottom frame of a forward suspension bracket
   11.11. A nave of a back wheel
   11.12. Replacement of bearings of a back nave
   11.13. The shock-absorber of a back suspension bracket
   11.14. A cylindrical spring of a back suspension bracket
   11.15. A pin of a nave of a back suspension bracket
   11.16. The bottom lever of a back suspension bracket
   11.17. The top lever of a back suspension bracket
   11.18. The directing lever of a back suspension bracket
   11.19. Draught of a back suspension bracket
   11.20. The stabilizer of cross-section stability of a back suspension bracket
   11.21. A side scene of the stabilizer of cross-section stability of a back suspension bracket
   11.22. A steering wheel
   11.23. A steering column
   11.24. An intermediate shaft of a steering column
   11.25. The ignition lock
   11.26. The steering mechanism
   11.27. Replacement of protective covers of the steering mechanism
   11.28. Removal of air from system of a steering with the amplifier
   11.29. The pump of the amplifier of a steering
   11.30. The spherical hinge of steering draught
   11.31. Steering draught
   11.32. Corners of installation of wheels
+ 12. A body
+ 13. An electric equipment
+ 14. The basic malfunctions

11.24. An intermediate shaft of a steering column Removal

PERFORMANCE ORDER

1. Remove a steering column.

2. Lift a forward part of the car and fix on supports.

3. Put combination labels on an intermediate shaft and a gear wheel of the steering mechanism. Unscrew a tightening nut and a bolt of fastening of an intermediate shaft. At installation use a new nut.

4. Unscrew 3 nuts, крепящие a sheeting of an intermediate shaft to a partition of a motor compartment.

5. From an internal part of the car shift a sheeting from an intermediate shaft and remove an intermediate shaft from the steering mechanism.

Check

PERFORMANCE ORDER

Check up an intermediate shaft on deterioration and damages. If there is a damage of a rubber sheeting, it is necessary to replace it.

Installation

PERFORMANCE ORDER

1. Combine the labels put before removal of an intermediate shaft, and pull an intermediate shaft over a gear wheel of the steering mechanism.

2. Establish a rubber sheeting on an intermediate shaft on a partition of a motor compartment.

3. From under the car establish tightening a bolt of an intermediate shaft and fix its new nut, having tightened its demanded moment.

4. Establish and tighten nuts of fastening of a sheeting.

5. Establish a steering column.